O- ring for TYGA silencer 2 stroke

Decal, Fuel Tank, Kawasaki, Silver, Ninja 250R 2008 -12

Seal, Clutch Pusher, MC28 SE/SP

Console, (Carbon) KTM RC125/200/250/390

Replacement part to be used on TYGA upper cowling BPCU-7231(p)

Passenger Seat Cover, (Carbon), Ducati Monster

Kit, Seat Set, GRP, (Street), MC21, MC28, NSR250V

Modelled closely from the seat cowling taken off an actual NSR500V HRC factory machine, this seat cowling kit has been designed to faithfully reproduce the appearance and silhouette of the NSR500V but in proportion to the NSR250. This seat cowling set can be installed with both the MC28 and the MC21, (though to fit it on a MC21 you will need an MC28 fuel tank or TYGA Fuel tank BPCG-0001 or BPFG-0001). The set consists of the parts shown below and has a taillight for street use and special mounting hardware and seat pad provided.

We have designed the seat cowling so that for fuel tank removal, there is no need to remove the seat cowling, making for quick and easy jet changes and maintenance etc. Note, you do not need to change the subframe for either the MC21 or MC28 models to install this seat cowling which bolts to the stock subframe holes at the rear and special front lower subframe mounting positions with all hardware provided. The seat cowling has threaded holes in the underside to attach exhaust stays TYLY-0243L and TYLY-0243R for use with NSR250V exhaust system EXCS-0047

We recommend installing this seat cowling set with fairing set BPFS-0195 on the NSR250 to complete the NSR250V bodywork style. For a complete transformation of the whole bike, we also recommend exhaust system EXCS-0047 and EXSL-0083 or EXSL-0084.

Number Board, (Carbon) MiniRacerXtreme, MSX125 Grom

This product fits over the front of the fairing on the MiniRacerXtreme to tranform the fairing from street to race. Easy installation and can be used with or wothout the headlight installed.

Turn Signal Relay, Replacement for Honda 1990s Type.

Electronically speed controlled flasher relay especially designed to be used with LED turn signals. This unit will flash at the correct speed regardless of the wattage of the turn signals so it can be used with stock fronts and LED rears, all LEDs or even all stock.* Easy to install, plugs and plays where the stock Honda one is installed. Re-use the stock Honda rubber sheath for mounting it.

*For some Hondas such as the MC21, NC30 and NC35, this relay works fine with 2 LED turn signals installed or with all four of the stock turn signals installed. However, if 4 LED turn signals are installed, then you need to install one of the following in the wiring harness: