Upper cowling “stock”, Honda VFR750 RC30 (hon-10569)

Direct replacement for OEM Honda lower cowling with headlight and indicator holes filled in. Due to being constructed with strong flexible epoxy resin, it is thinner and therefore about 65% the weight of the stock upper cowling. In every other way, the same as stock. Can be used with TYGA Performance or factory Honda RC30 lower cowlings.

Carbon tank cover. Fits over nasty the plastic stock item and transforms the appearance of your bike. Installs in minutes. Note, we also offer BPCX-9828 which is a direct replacement for the plastic Honda cover for those people wanting to get their tools out and wishing to make a more permanant transformation.

Boyesen Dual reeds, Yamaha RD350

Boyesen Power Reeds use a patented dual-stage fiberglass design for more airflow, more air velocity and more overall power.

Boyesen dual-stage power reeds produce a better throttle response right off idle and through the mid-range when compared to the traditional Power Reed setup.

1 engine = 1 set

This handy tool can be used to hold shafts, bolts or any round object securely.

Just select the correct hole size and clamp it all up in the vice

Manufactured from 6061 aluminum for strength and durability, it will clamp most metallic components without damage

Shaft sizes: 11mm, 12mm, 13mm, 14mm, 15mm & 16mm.

I’ve been using this tool for so long, for so many applications that it seemed only fair to share it!

All necessary seals and bearing to rebuild your NSR250SP/R waterpump.

Please note that it is necessary to remove the clutch cover to overhaul the waterpump, so a clutch cover gasket may also be required.

Replace the heavy steel rear wheel spacer and wheel bearing distance spacer on the VJ22 with these lightweight 6061-T6 aluminium spacers. At 35% of the weight of standard they’re just what you need for easier wheelies!

Airbox, Carbon/Kevlar, NSR250 MC21/MC28

This high quality carbon/Kevlar air box is an adaptation of the HRC air box and has the following features.

Maximum volume, more than double the size of the stock air box for better flow and power
High flow, large area foam filter for street use
Snug fitting rubber base to prevent leaks around carb insulators
Designed to be used with a full street harness as well as race harness
Can be used with MC21 and MC28 models or combination of either model (fuel tanks, harnesses and carburetors)
Allows for use of carburetor solenoids and supplied with special mounting hardware
Allows for use of two stroke oil pump and supplied with holes for cables and lines as well as blanking plugs
Uses HRC seal gap , part number 64234-NX5-770 for a good seal with the fuel tank
Built in high grade epoxy and carbon/kevlar for beauty and light weight
Provided with a hole and seal for external fuel cock as well as a short type for racers who want ease of removal of fuel tank.
See also similar product in GRP: BPFX-0007

Piston No mark, MC21/28